Connection guide, E-12, Dvd player – Arcam FMJ AVR600 User Manual

Page 14: Satellite receiver, Cd player, On the avr600

E-12

�

��

�

��

��

�

��

�

��

��

��

��

�

��

�

��

��

��

�

��

��

��

��

��

��

��

��

��

��

��

��

��

�

��

��

��

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

��

��

��

��

��

��

�

��

��

��

��

�

��

�

��

�

��

�

��

�

��

�

��

Connection guide

dVd player

The diagram shows how to make audio and video

connections from a typical DVD player.
The preferred video hook-up, in order of preference is:

use the HDMI connector (if HDMI output is

provided by the player), otherwise connect the three

Component or four RGB+Sync video connectors.

use the S-Video connection if HDMI or Component

/RGB+Sync outputs are not provided by your player.

use the Composite connection if HDMI,

Component/RGB+Sync or S-Video are not provided

by your player.

In each case, connect the video inputs labelled

DVD

the AVR600.
The preferred audio hook-up is using the coaxial digital

connector (usually marked

DigiTAl AuDio ouT

), in

addition to the coaxial analogue outputs for left and

right channels.
In each case, use the audio inputs labelled

DVD

on the

AVR600.

Satellite receiver

A satellite receiver is connected in the same way as

a DVD player, with the same order of preference

according to the outputs provided by the satellite

receiver.
In each case, use the inputs labelled

SAT

on the AVR600.

Note that digital audio input from a satellite receiver

sometimes requires a coaxial/TOSLINK (digital

connector) interconnect cable, as some satellite receivers

do not implement audio over HDMI properly or at all.

Cd player

Connect the digital audio output (if provided by the CD

player) to the digital

input of the AVR600, using a

high quality coaxial interconnect cable.
Connect the right and left analogue audio outputs of

the CD player to the analogue

inputs of the AVR600,

using a pair of high quality coaxial interconnect cables.