Arcam FMJ AVR600 - Manual (Page 23)

E-21
English
Using Zone 2 and 3
Zone 2 provides the option for the occupants of the
master bedroom, conservatory, kitchen, etc. to view or
listen to a different source at a different volume level
from the main zone (Zone 1).
Zone 3 provides for a third living space to have a copy of
the audio signal in Zone 2 at a different volume level.
Extended front panel menu
Pressing the MEnu key and holding it for longer than
four seconds will bring up the Extended Menu, allowing
you to perform the following:
Restore to factory defaults
This option allows you to restore all settings on your
AVR600 to the defaults that it left the factory with. Note
that this also erases any secure backups stored on the
AVR600.
Change remote code
The default RC5 system code the AVR600 responds to
is 16. If required, for example due to another device in
your system also using this RC5 system code, it can be
changed to 19.
Updating firmware using a PC
Using a PC application (available on request from
Arcam), you can update the firmware in your AVR600
using the back panel RS232 port connected to your PC.