Arcam FMJ AVR600 - Manual (Page 56)

E-54
trouble-
shooting
Problem Check that...
There are no lights on the unit < the power cord is plugged into the AVR600 and the mains socket it is
plugged into is switched on.
< the power button is pressed in.
If a red LED is present, the AVR600 is in standby mode. Press any button on the
front panel or remote control.
The unit responds erratically
or not at all to the remote
control
< there are fresh batteries in the remote control.
< the front panel window is visible and you are pointing the remote control
towards it.
The front panel display is
blank
< the display hasn’t been turned off. Press the DiSplAy button on the front
panel or remote control.
No picture is being produced < your viewing device is turned on and switched to display your AVR600. Test
by pressing the MEnu button on the AVR600 or on the remote and look for
the main menu screen on your display device.
< the correct video input is selected on the AVR600.
< the video source is on, is operating normally, and is in ‘play’ mode if
appropriate.
< you have the AVR600 in a video resolution that is compatible with the
connection you are using and with your display device. For example,
composite video is only capable of carrying 480i and 576i resolutions. Test
this by pressing and holding the OK key for more than two seconds to force
480i / 576i output resolutions.
There are bright edges or
‘ghosts’ on the picture
< the cables used for analogue video connections are designed to carry video
(i.e., they are 75 Ω coaxial cables).
< ensure the ‘sharpness’ control on your display device is switched off or set to
near minimum.
< for HDMI connections, try using a shorter cable or alternatively a different
brand.
No sound is produced < the correct input has been selected.
< the source equipment is on, is operating normally and is in ‘play’ mode if
appropriate.
< the volume is turned up to a reasonable level and the AVR600 is not in mute
mode.
The sound is poor or distorted < you have not excessively increased the input sensitivity (i.e. reduced the
maximum input signal voltage) in the Input Config. menu if an analogue
input is being used.
< you have selected the correct size of speakers to suit your system in the setup
menu.