LevelOne HVE-9900 - Manual (Page 11)

10
Note for DIP switch
1 If the HDTV shows video but without audio, please set audio mode to stereo.
2 Factory default setting is pin-1 at OFF [©], pin-2 at OFF [©] for 1080p with stereo.
3 If you encounter any unsolved audio/video output problem during system installation,
please dial the DIP switch to pin-1 at OFF [©], pin-2 at ON [ª] for safe mode to enforce
the most compatible 720p stereo output for system check. However, the safe mode
cannot be initiated if your HDMI sources are set to enforce 1080p output. In this case,
please reconfigure your HDMI source to all resolution output for troubleshooting.
4 Bypass means this device will maintain playing the original format of HDMI signals in
video and perhaps audio. By setting at this mode, the users may encounter
compatibility issue among different kinds of HDMI sources and displays. If you cannot
get the audio and/or video output normally at the system installation, please change
the DIP switch setting to default mode or even safe mode to verify the functionality of
the device.
5 For EDID learning function please see the next section.
EDID Learning
1. To make the HVE-9004 learn the EDID of the desired display, connect the display to
the HDMI INPUT port via a HDMI cable.
2. Set the DIP switch position pin-1 at ON [ª].
3. Reboot the HVE-9004 and you should see the green LED SIGNAL on the front panel
blinking to indicate the EDID learning sequence is underway. The EDID learning
sequence is complete when the LED stops blinking.
4. Resume the installation. Connect the sources back to HDMI inputs and let the
displays connect to the receiver units via Cat.5e/6 cable.
5. Set the DIP switch pin-1 at OFF [©] will erase the EDID profile learned from the display
and restore the default EDID profile. So please do not dial the pin-1 back to OFF [©]
unless you want to use default EDID profile or learn new EDID from different HDMI
display.