LevelOne WAB-6120 - Manual (Page 52)

Chapter 5 Management Page 42
Restore factory default settings via Reset Button
If software in LEVELONE 150MBPS WIRELESS POE AP is unexpectedly crashed and no longer
reset the unit via Web, you may do hardware reset via the reset button. Press and hold the button
for at least 5 seconds and then release it until the PWR LED gives a blink.
Reboot
You can reboot your LEVELONE 150MBPS WIRELESS POE AP from “Configuration File” in
“Management” as below:
Click “Reboot” and hit “Yes” upon the appeared prompt to start reboot process. This takes a few
minutes.
Figure 37 Reboot
System Log
System log is used for recording events occurred on the LEVELONE 150MBPS WIRELESS POE AP,
including station connection, disconnection, system reboot and etc.
Open “System Log” in “Tools” as below.