LevelOne WAB-6120 - Manual (Page 29)

Chapter 3 Basic Settings Page 19
configure the parameters of LEVELONE 150MBPS WIRELESS POE AP for accessing the
Internet.
Figure 16 IP Settings (Router)
WAN Settings: Specify the Internet access method to Static IP, DHCP or PPPOE. Users must
enter WAN IP Address, Subnet Mask, Gateway settings provided by your ISPs.
LAN Settings: When DHCP Server is disabled, users can specify IP address and subnet mask
for LEVELONE 150MBPS WIRELESS POE AP manually. Make sure the specified IP address is
unique on your network in order to prevent IP conflict. When DHCP Server is enabled, users may
specify DHCP IP Address Range, DHCP Subnet Mask, DHCP Gateway and Lease Time
(15-44640 minutes).
In AP mode, LEVELONE 150MBPS WIRELESS POE AP must establish connection
with another wireless device before it is set to Router mode. In Router mode, it is
impossible for users to access device via wired port, for WAN is on wired port and LAN
is on wireless port. Users can access device through the wireless device connected
with LEVELONE 150MBPS WIRELESS POE AP.
In CPE mode, users can access LEVELONE 150MBPS WIRELESS POE AP via its
wired port, for WAN is on wireless port and LAN is on wired port when device is set to
Warning: