LevelOne WAB-6120 - Manual (Page 47)

Chapter 5 Management Page 37
Chapter 5 Management
SNMP Management
The LEVELONE 150MBPS WIRELESS POE AP supports SNMP for convenient remote management.
Open “SNMP Configuration” in “Management” shown below. Set the SNMP parameters and obtain
MIB file before remote management.
Figure 31 SNMP Configuration
Enable SNMP
Check this box to enable SNMP settings.
Protocol Version
Select the SNMP version, and keep it identical on the LEVELONE 150MBPS WIRELESS POE AP
and the SNMP manager.
Server Port
Change the server port for a service if needed; however you have to use the same port to use that
service for remote management.
Get Community
Specify the password for the incoming Get and GetNext requests from the management station. By