American Power Conversion MX28B-400 - Manual (Page 7)

MX28B-400 +24V Product Manual
990-9218 1
1. GENERAL INFORMATION
1.1 Introduction
DC Power Plants from APC DC Network Solutions Inc. have unique features that make them
easy to install, maintain, and upgrade. The rectifier units are modular and truly “hot-pluggable”
into the shelf assembly without any separate ac wiring.
All system settings are made from the system control unit that provides monitoring and control
functions for each component of the system as well as alarm listings for system diagnosis and
maintenance.
The APC DC Network Solutions Inc.. International network of sales and service offices and
qualified representatives provides sales assistance for proposals, purchases, and after-sales
support.
APC DC Network Solutions Inc. provides nationwide 24-hour, 7-day service response by
dialing:
(800) 800-4APC
This service will answer your call, gather specific service information, and have a qualified APC
service representative contact you as quickly as possible (refer to section on customer service
and support).
1.2 Precautions
It is extremely important to read, understand, and strictly follow the instructions in
sections on installation and setup. Also, please note the special SAFETY PRECAUTIONS
outlined in Section 5.1.4 before beginning actual installation of the power system.
If any precautions are not clearly understood, or local conditions are not covered, contact the
nearest APC DC Network Solutions Inc. Representative or APC DC Network Solutions Inc.. at
(800) 800-4APC for clarification.
Also, refer to all applicable federal, state, and local regulations, and industry guidelines for
correct installation of this power system.
1.3 Inspection upon Receipt of Goods
1.3.1 General
APC DC Network Solutions Inc. has taken precautions in packing the power equipment for
shipment to ensure its safe arrival; however, the entire shipment including any boxes or crates
should be inspected upon receipt for evidence of damage that may have occurred during transit.
1.3.2 Visible External Damage
It is the responsibility of the person receiving the shipment to inventory and inspect all materials
against the bill of lading or waybill provided IMMEDIATELY upon taking delivery while the
carrier representative is STILL ON SITE. Please be sure that all items are accounted for,
including the correct number of pallets and the quantity of accessory and/or component boxes.
Also, note any visible external damage that may have occurred during transit.