Inter-M HDCC-400 - Manual (Page 17)

J-BOX :OFF
DOME1 2400~38400 None/Dome/DVR5
DOME2 2400~38400 None/Dome/DVR1-5/PC-DVR/ KBDDUP/KBDTRI/AUX IN
RS232 2400~38400 None/DVR1-5/PC-DVR/AUX IN
J-BOX :ON
DOME1 2400~38400 RS485 :None/Dome
D2/DVR 2400~38400 RS485 :None/Dome/DVR1-5/PC DVR/AUX IN
ALARMPC 2400~38400 RS232 :None/AUX IN
MUX/KBD 2400~38400 RS485 :None/DUPLEX/TRIPLE /AUX IN
DVR/AUX 2400~38400 RS232 :None/DVR1-5/PC-DVR/AUX IN
KBDDUP : Keyboard + Duplex Multiplexer
KBDTRI : Keyboard + Triplex Multiplexer
AUX IN : outputs the auxiliary signal input to Dome1(FASTRAX,PELCO only)
Note: When the DVR is selected at a port, the other port displays the same DVR only. To change the DVR
number at the other port, first change the current DVR number to none.
Note: JBOX is an optional device that is not included with the KBD.
JBOX menu has to be set to OFF in the menu if you do not have this optional JBOX.
MUX Config (Multiplexer Configuration)
This screen allows you to set multiplexer switching settings when you select the camera by pressing NO +
CAM. Up to 64 Cameras can be installed using 5 MUXs and 4 keyboards. It is equivalent to a 64x4 matrix
system. Each four users can view one of 64 cameras to his own SPOT(AUX) monitor.
This menu is for assignment when multiplexers are installed in two levels. Two levels means that spot outputs
of the first level multiplexers is connected to the video input of the second level multiplexer.
Press NO + CAM will display the selected camera on the spot output of the second level multiplexer.
MUX Channel: NO(no use), 16, 28, 32, 48, 64 – Select the MUX channel number used in the multiplexer
configuration.
When you select the desired number, the MUX configuration table is made automatically according to the
number as the figure 8.
MUX Config
1.MUX Channel : 16
2.Set MUX A
3.Set MUX B
Save and Exit