Inter-M HDCC-400 - Manual (Page 16)

This screen allows you to change administrator password.
Enter 4 digits password and press ENTER . Factory Default setting is 9999.
Note) Factory default Administrator’s password is 9 9 9 9 + ENTR .
User password is 1 1 1 1 + ENTR
If you forgot your own password, contact service personnel or distributor.
3.2 Network
1. J-BOX Set: OFF Select to use the optional Junction Box or not.
2. Set Port Select the baud rate and the connected unit’s protocol.
3. MUX Config Set the multiplexer configuration.
4. Set Slave KBD Select to use the slave keyboard or not.
Save and exit Save the changed settings and return to the previous menu
Set Port
Set Baud Rate Enters the Baud Rate setup submenu.
Com Ports Enters the Communications Ports setup submenu.
Exit Return to the previous menu.
Set Baud Rate
< J-BOX :OFF> < J-BOX :ON>
Com Ports
1.Set Baud Rate
2.Com Ports
Exit(ESC)
Set Baud Rate
1.DOME1 : 9600
2.D2/DVR : 9600
3.ALARMPC : 9600
4.MUX/KBD : 9600
5.DVR/AUX : 9600
Save and Exit
Set Baud Rate
1.DOME1 : 9600
2.DOME2 : 9600
3.RS232 : 9600
Save and Exit
Com Ports
1.DOME1 : DOME
2.DOME2 : NONE
3.RS232 : NONE
Save and Exit
Com Ports
1.DOME1 : DOME
2.D2/DVR : NONE
3.ALARMPC: NONE
4.MUX/KBD: NONE
5.DVR/AUX: NONE
Save and Exit
< J-BOX :OFF>
< J-BOX :ON>