Harrington Hoists and Cranes CB Hand Chain Hoist - Manual (Page 10)

10
2.3.2 Optional Inspection Hooks
 The Inspection Hook is designed to facilitate the inspection of the internal surfaces of the hook
yoke and shank portion of the hook itself. The Inspection Hook is suitable for applications where
inspection of the internal parts of the hook set is required. The inspection hook uses the standard
Harrington hook set and is assembled with high-strength locking fasteners instead of rivets.
Inspection hooks are available in top and bottom versions. Refer to Figure 2-7.
 Disassembly and re-assembly involves removal and reinstallation of the yoke fasteners of the
Inspection Hook Set Assembly followed by testing of the hoist prior to returning it to service.
 The Inspection Hook is available for CB005 through CB025 hoists.
 See Section 9.4, Parts List for a complete Inspection Hook part listing.
 See Table 6-3 for yoke nut torque specifications.
Figure 2-7 Inspection Hooks
2.3.3 Optional Chain Containers
 Chain containers are sized based on the capacity and lift of the hoist. The containers are
constructed from vinyl coated canvas with a steel frame on top. The containers are prepared
differently depending on the host model. See Harrington document EDOC0154 for sizing
information.
Figure 2-8 CB Chain Container