SKC 575-005 Series Passive Sampler - Manual

Operating Instructions
863 Valley View Road, Eighty Four, PA 15330 USA
Tel: 724-941-9701 Fax: 724-941-1369 e-mail: [email protected]
SKC Ethylene Oxide Passive Sampler
Cat. No. 575-005
The SKC Ethylene Oxide Passive Sampler is a small ready-to-use sampler that
provides superior collection of ethylene oxide (EtO) without the use of a sample
pump. SKC has scientifi cally validated the sampling rate for EtO and other critical
parameters of the SKC Ethylene Oxide Passive Sampler to meet OSHA/ANSI/ISEA
requirements. The SKC Ethylene Oxide Passive Sampler contains the same sorbent
that is specifi ed in active OSHA Method 1010.
Performance Profi le
Sorbent/Amount: Anasorb ® 747 coated with hydrobromic acid, 500 mg
Housing material: Nylon
Diameter: 1.4 in (3.5 cm)
Length:
(including clip)
2.5 in (6.3 cm)
Depth: 0.6 in (1.5 cm)
Concentration range: 0.1 to 4 ppm
Analysis: Solvent desorption, Gas Chromatography/Electron Capture
Detector (GC/ECD)
Shelf-life: 18 months at < 39.2 F (4 C)
Storage: Before use: Store at < 39.2 F (4 C).
Aft er use: Store at < 39.2 F (4 C) for up to 3 weeks.
Expedited shipping is recommended.
Do not store with food.
Sample time: Validated for 15-min and 8-hr occupational exposure
sampling
Sampling rate: 21.2 ml/min