SecurityMan DigiLCDDVR Series User Manual

Page 32

• Add/Remove Camera

The

Add/Remove Camera option is used to add/remove cameras to or

from LCDDVR. Camera 1-4 shown in the image below represent all the
channels available on your system (a

LOCK symbol represents a camera

that is already registered to that channel and an

UNLOCK symbol

represents an available channel that is free). To access these options
simply highlight and push the

OK button on the Add/Remove Camera

option.
NOTE: By default the camera(s) that come with your DigiLCDDVR kit will
be added in sequence from Camera 1-4.

• • Adding Cameras

To add a camera to your system simply highlight any of the available
cameras/channels (unlocked) and press the

OK button on the LCDDVR.

Once selected, a confirmation screen will pop up asking you to confirm
(

YES) or cancel (NO) your selection, use the LEFT and RIGHT buttons

to make your selection and press the

OK button to confirm. During the

registration process a pop up window showing “

Add/Remove Camera”

will be displayed for approximately 10 seconds. At this time press the
pairing button located on the back of the camera a few times until you
get a confirmation stating that “pairing was successful”.
NOTE: When adding a camera, the Pair button located on the back of
the camera must be pressed consecutively after pressing the

OK button