Rivers Edge RE634 2 MAN - Manual (Page 7)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 7
Operator's Manual
Rivers Edge® Two-Man Ladder Stands
10. Attach the previously assembled shooting rail to the tabs located on
the shooting rail extension tubes using (2) provided 1/4-20 x 1-3/4”
bolts, locknuts, steel washers and nylon washers. SEE fIGuRE 7. You
must now tighten all nut and bolt combinations completely. Be
sure not to over tighten or crush tubing when tightening.
11. a. Attach the removable seat cushion (48814) to the top of seat frame.
Wrap the Velcro seat straps or buckle straps around seat frame and
secure together. Snap the side release buckles together for buckle
style seats. Pull straps tight so seat is not loose. Attach backrest por-
tion by wrapping Velcro around backrest rail and securing.
b. Attach the (2) provided 9” and (1) provided 36” camo foam
sleeves to the side loop frames and shooting rail by wrapping
around square tubing and attaching Velcro together.
12. Sections are assembled on the ground in the following order; bot-
tom section (410044 base extension); second section (10468 3-step
ladder); third section (10470 3-step ladder w/ stabilizer bar mount);
fourth section (10468 3-step ladder); top section (assembled top
platform section). SEE fINIShED 2-MAN lADDER.
13. With all sections assembled together on ground, secure all sections
together using (8) provided spring lock pins. Handle of spring lock
pin must be put to the outside of ladder side rails. SEE fIGuRE 8.
14. a. Attach the stabilizer bar extension tube (1ML23) to the second
ladder section mounting bracket using (1) provided spring lock
pin. SEE fIGuRE 9.
b. Slide the stabilizer bar (L17) into the extension tube and attach
the two pieces together using (1) provided spring lock pin. Spring
lock pin must go through both the extension tube and stabilizer
bar at appropriate hole to achieve desired distance from tree. Ad-
justment in length may be needed when ladder is uprighted later
in instructions. SEE fIGuRE 9.
15. a. Tie one end of the provided 9’ rope to the link welded onto the
stabilizer bar, just in front of the tree hugger. Be sure your double
knots are secure. SEE fIGuRE 10.
b. Tie one end of each of the provided 15’ ropes to the tree blade
extension tubes, just in front of the bolt-on tree blade. Be sure your
double knots are secure. SEE fIGuRE 10.
Figure 7
locknuts
shooting rail
rail extension
tube tabs
1/4-20 X 1-3/4" bolts
locknuts
nylon wash-
ers
steel washers
Figure 8
spring lock pins
spring lock pins
Figure 10
Figure 9
spring lock pins
stabilizer bar extension
tube
stabilizer bar
mounting bracket