beautypg.com

Warning, Rivers edge® two-man ladder stands, Back view of tree – Rivers Edge RE634 2 MAN User Manual

Page 17

background image

Check for parts online at

www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5

17

Operator's Manual

Rivers Edge® Two-Man Ladder Stands

WARNING

DOuBlE ChECk ASSEMBlY STEPS TO BE CERTAIN YOu hAvE

CORRECTlY ASSEMBlED ThIS PRODuCT.
STuDY YOuR NEW STAND TO BECOME fAMIlIAR WITh All Of

ITS fEATuRES AND DESIGN. AT GROuND lEvEl, fOllOWING

PROvIDED uSE INSTRuCTIONS, PRACTICE ATTAChING STAND

TO TREE AND REMOvING STAND fROM TREE. PRACTICE SIT-

TING, STANDING, AND uSING ThIS PRODuCT BEfORE ATTACh-

ING OvERhEAD. SAvE ThESE INSTRuCTIONS fOR fuTuRE REf-

ERENCE. YOu MuST AlWAYS uSE ThE PROvIDED full BODY

hARNESS (fAll ARREST SYSTEM) ThAT MEETS TMA STAN-

DARDS WhIlE uSING ThIS PRODuCT.
AlWAYS uSE ThREE PEOPlE fOR SET-uP AND TAkE-DOWN.
BE ABSOluTElY SuRE ThE TREE BlADES ON PlATfORM

AND ThE STABIlIZER BAR ARE BOTh CONTACTING TREE BE-

fORE ClIMBING lADDER.
STABIlIZER BAR MuST AlWAYS BE CORRECTlY AND SE-

CuRElY ATTAChED TO lADDER AND TREE BEfORE ClIMB-

ING lADDER.
SOME MODElS INCluDE A MulTI-PIECE STABIlIZER BAR

SYSTEM. BE SuRE SPRING lOCk PIN GOES ThROuGh BOTh

ThE EXTENSION TuBE AND ThE STABIlIZER BAR.
BE CERTAIN SPRING lOCk PINS ARE lATChED SECuRElY TO

PREvENT ACCIDENTAl REMOvAl.
BE SuRE YOuR DOuBlE kNOTS ARE All SECuRE ON All

ROPE CONNECTIONS.
NEvER ASCEND OR DESCEND lADDER WIThOuT TIE-Off

ROPES SECuRElY hOlDING lADDER TO TREE AND STABIlIZ-

ER BAR SECuRElY ATTAChED. fAIluRE TO CORRECTlY PER-

fORM ThESE STEPS CAN CAuSE ThE lADDER TO COllAPSE/

BuCklE-OvER BACkWARDS DuRING ThE INITIAl ASCENT TO

ATTACh RATChET STRAP RESulTING IN SERIOuS INJuRY OR

DEATh.

Figure 1b (RE629)

15' tie-off ropes

BACk vIEW Of TREE

backrest tree

blade

seat tree

blade

ratchet strap

ratchet strap

SETuP AND uSE INSTRuCTIONS

During installation and removal of ladder treestands, you must

always and properly use the included Full Body Harness (Fall Arrest

System). Refer to the Full Body Harness instructions included with

this product for proper use.

1. With assembled product lying on the ground in assembled position,

position one person at bottom end of ladder lying on the ground.

This person has to prevent the ladder end from tilting up when platform

end is lifted and prevent the ladder from skidding across ground.

2. a. Position (2) people at the platform end of the ladder, lift the

platform end and continue uprighting by walking toward bottom

end of ladder and moving hands along ladder legs. Stand ladder

up against chosen straight tree on dry, level ground. Use caution

when ladder comes over center against the tree.

b. Step back and look at the ladder top to see that both platform tree

blade and upper tree blade are contacting tree. Adjust as needed

so both the tree blades are contacting tree.

c. Step down hard on bottom step to push ladder legs into the

ground.

d. Wrap the 9’ rope attached to stabilizer bar around tree and tie

the free end to the link welded on stabilizer bar at the stabilizer bar

height location. Secure the ladder tight so the stabilizer bar is at a

right angle to the tree. Adjust stabilizer bar length as necessary so

it contacts tree. Be absolutely sure the tree blade on platform, the

upper tree blade and the stabilizer bar are all contacting tree.

e. Wrap the previously attached 15’ tie-off ropes hanging down from

platform, around the back side of tree in opposite directions of each

other. Pull the ropes snug and tie them to the ladder at the stabilizer

bar height location. This ground level ladder-to-tree attachment will

prevent the ladder from pulling away from the tree while ascending

to top for final ratchet strap attachment. The same holds true when

ladder removal is necessary. SEE fIGuRE 1a and 1b.

Figure 1a (RE633)

15' tie-off ropes

BACk vIEW Of TREE

upper tree

blade

platform tree blade

ratchet straps

WARNING

NEvER ASCEND OR DESCEND lADDER WIThOuT TIE-Off

ROPES SECuRElY hOlDING lADDER TO TREE AND STABIlIZER

BAR SECuRElY ATTAChED. fAIluRE TO CORRECTlY PERfORM

ThESE STEPS CAN CAuSE ThE lADDER TO COllAPSE/BuCklE-

OvER BACkWARDS DuRING ThE INITIAl ASCENT TO ATTACh

RATChET STRAP RESulTING IN SERIOuS INJuRY OR DEATh.

This manual is related to the following products: