Rivers Edge RE627 Oasis - Manual (Page 24)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 24
Operator's Manual
Rivers Edge® One-Man Ladder Stands
AssEMBlY INsTRuCTIONs (RE630)
Tools needed – two 7/16” wrenches, Phillips screw driver
IMPoRtant assEMBlY tIP: do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! this will temporarily hold the lock nut on the bolt while
helping alignment of all parts! after all parts are assembled together, all nut
& bolt combinations must be completely tightened.
1. Attach the tree blade (10344) to the main ladder side rails (10346) us-
ing (4) provided 1/4-20 x 2-1/4” bolts, locknuts and steel washers. sEE
fIGuRE 1. DO NOT tighten all nut and bolt assemblies completely!
2. Insert the crimped end of two flared rails (10338) into the main
side rails. Secure using (2) provided 1/4-20 x 1-1/2” bolts, locknuts
and steel washers. sEE fIGuRE 2. Pay special attention to orienta-
tion of flared rails.
3. Attach the foot platform (10340) to the inside of flared rails using
(2) provided 1/4-20 x 2-1/4” bolts, locknuts and steel washers. sEE
fIGuRE 2.
notE: Mesh surface of foot platforms should be on top with
square ends of platform near flared rails.
4. a. Attach the 2-hole (slot) end of upper ladder support tubes
(10336) to the bottom side of main side rails using (4) provided
1/4-20 x 2-1/4” Phillips head bolts and locknuts. sEE fIGuRE 3.
b. Attach the 1-hole (slot) end of upper ladder support tubes to
the backside of flared rails using (2) provided 1/4-20 x 2-1/4” bolts,
washers and locknuts. sEE fIGuRE 3.
c. Attach the foot platform to the upper ladder support tubes
using (2) provided 1/4-20 x 2” bolts, locknuts and steel washers.
sEE fIGuRE 3.
Figure 1
tree blade
steel washers
1/4-20 x 2-1/4" bolts
main ladder side rails
locknuts
Figure 2
locknuts
1/4-20 x 1-1/2" bolts
steel
washers
steel
washers
locknuts
1/4-20 x 2-1/4" bolts
foot platform
flared rails
main ladder
side rails
Figure 3
upper ladder
support tubes
1/4-20 x 2-1/4"
Phillips head bolts
locknuts
1/4-20 x 2-1/4"
bolts
1/4-20 x 2" bolts
steel washers
locknuts
steel washers
locknuts
foot platform