beautypg.com

Rivers Edge RE703 Outpost User Manual

Page 8

background image

TREESTANDS

10' Outpost

Tower w/ Blind Kit (RE703)

Page 8

HuntRiversEdge.com

HuntRiversEdge.com

800-450-EDGE (3343)

17. a. Attach the opposite end of all four double flat braces to the wing

bracket of each top leg section using (4) provided 5/16-18 x 1-1/4” bolts
and locknuts.

SEE fIGURE 11.

IMPORTANT NOTE: Be sure to use 1-1/4” bolts at any location

where multiple cross brace poles are attached!

b. Attach (2) cross brace assemblies to wing brackets of leg sections,
on each side of the tower (8 total cross brace assemblies), using (12)
provided 5/16-18 x 3/4” bolts, (4) 5/16-18 x 1-1/4” bolts and (16) locknuts.
SEE fIGURE 11.

NOTE: You will use the 5/16-18 x 1-1/4” bolts and nuts that are

already holding the double flat braces.

18. Once all cross braces are attached to tower legs,

you must now

tighten all nut & bolt assemblies. Be sure not to over tighten or
crush tubing when tightening! Double and triple check all nut and
bolts to make sure all are securely fastened.

fIGURE 11

locknuts

wing brackets

5/16-18 x 3/4" bolts

cross brace assemblies

5/16-18 x 1-1/4" bolts

5/16-18 x 3/4" bolts

double flat braces