Rivers Edge RE703 Outpost User Manual

Page 10

TREESTANDS

10' Outpost

™

Tower w/ Blind Kit (RE703)

Page 10

HuntRiversEdge.com

800-450-EDGE (3343)

22. Attach assembled ladder to the platform using (2) provided 1/4-20 x 1-

3/4” bolts and locknuts.

SEE fIGURE 13. Plate of top ladder section

should be mounted on top side of platform.

NOTE: Ladder can be bolted to long side of either platform, they

are the same.

23. Attach the ladder assembly to the cross braces using the (2) provided

U-bolts/backup plates/nyloc nuts and tighten securely. This will hold the
ladder securely to the cross braces.

SEE fIGURE 13.

24. Go over every detailed step of assembly to be sure all assembly is done

correctly and all bolt locations are secured and snug.

Be sure not to

over tighten or crush tubing when tightening!

25. The camo blind cover (48028) can now be positioned over the upper

frame work.

NOTE: Supporting platform end of tower slightly off ground will be

needed to slide blind over frame work.

a. Locate the door opening and align it with the top of the ladder.

b. Stretch sewn in bungee cord on bottom edge of blind around platform
corners/edges to get a snug fit.

c. The webbing straps in each corner can be fed around the platform
J-pipes and back through platform mesh. Feed long strap through tri-slide.
Pull strap tight so blind will be attached to platform. repeat for all 4
corners of blind.

d. The Velcro straps located on each side can be fed around the platform
frame and back through platform mesh and secured.

fIGURE 13

1/4-20 x 1-3/4" bolts

locknuts

u-bolts

backup plates & nuts