RECON 26417 Bed Rail Light Kit User Manual
Page 7
Take one string of Recon bed lights and tape the pods to the holes with lights facing
inward. This gives the correct spacing and allows you to fold and zip-tie the excess
wiring for a tidy install.
Insert recon bed lights one at a time until each reaches their respective cut-out. Again if
your careful and cut the holes correctly the pods will fit snug in the opening. I later
drilled small holes opposite each cut-out and drove a machine screw through to contact
the backside of the light pod to prevent it from falling out. Additionally I applied some
epoxy around the cutout contacting the light pod.