RECON 264163 LED Dome Lights (Ford Superduty) - Manual (Page 2)

4) Remove the original spot light bulbs from the housing.
NOTE: LED lights are polarized and will only work if they are installed in the correct
direction
5) Holding the housing so the Ford logo faces you, install the LED bulbs. Noting the
direction of the text on the backside of the bulbs, the bulb on the right hand side should
have the text facing you and the bulb on the left side should have the text facing away
from you.
6) Reinstall the reflectors into the housing.
7) Reattach the power line to the housing and check the functionality of the spot lights.
Reattach the housing to the ceiling with the 3 Philips head screws.
8) With a door ajar carefully touch the contacts of the LED primary dome light to its
corresponding contacts. If the light does not turn on, flip the light around and contact the
opposite electrical contacts. If the light turns on, press the light into the housing by using
2 fingers in the center of the light.
NOTE: If you have to remove the LED primary dome light use a small screwdriver to
push the light from the backside of the bulb, do not pull the pc board.
9) Rotate the LED spot lights so they face out the ports
10) Reinstall the dome light lens