RECON 264143 Cab Lights (Ford F-Series) - Manual (Page 2)

RECON Truck Accessories 2008 Page 2 of 5 Installation Instructions Part # - 264143 Series
Installation Procedures for Factory FORD Clearance Lights
O
ne of the options folks want when they purchase their truck, are factory clearance lights. As dealers charge more than
$300 to install them, many folks choose to do it themselves. All that’s needed is a Ford wiring harness that comes installed
in the roof of trucks with factory installed clearance lights. The complete wiring harness is approx $30.00. You may have
to make a trip to a local hardware store such as Lowe’s or Home Depot to get flat washers and Nylock 5mm nuts for the
lights and a tube of clear silicone.
First thing you need to do is cover your dash to keep
shavings and stuff from falling into your interior. You have
to take down the front of your headliner to access the area for
the cab lights and to remove and install the harness. Remove
the plugs on the handle on the passenger side and then
remove the (4) bolts holding the handle on.... required a
5/16" socket.
Once the handle is removed, pop the pillar cover off. To get
it out tilt towards the drivers side and wiggle. It will come
out! Same thing with driver’s side.
Now you need to remove all the screws that hold the visors
parts in....