RECON 264155_264156 Cab Lights (Chevy-GMC) - Manual (Page 4)

RECON Truck Accessories 09/05 Page 4 of 4 Installation Instructions Part # - 264155 Series
Route the harness down the PS pillar and thru the opening at the corner of the pillar. Some find it’s
easiest to route mechanic’s wire first then use the wire to pull the wire harness down underneath the
glove box right behind the connector panel.
Install the fused lead that comes included with the kit to the hot wire and attach a female connector to the
ground wire.
Make sure you connect the power/ground wires correctly in the PS panel. Test each with a test light first.
Most newer Chevy/GMC’s 03’s have 3 spades. The bottom most spade is ground and the middle is the
marker lamp circuit.
Attach power and ground wires and test lights. Once the test proves a success, you’re ready to begin re-
assembly.
Re-Assembly
Simply re-install everything you removed earlier when dropping the headliner.
1. Install the PS grab handle
2. Re-install DS and PS pillars
3. Re-install both sun visors (Torx 15 and 20)
4. Reinstall center console.
If you have any questions, feel free to contact us:
[email protected] - www.GoRecon.com