Ransburg RF1 FiberOptic Meter 77786-XX, A11516-XX - Manual (Page 23)

FM-00-02.5 1 9 1 9 1 9 1 9 1 9
RF 1 Fiber Optic - Operation
Figure 17: View of Flated Portion of Shafts Figure 17: View of Flated Portion of Shafts Figure 17: View of Flated Portion of Shafts Figure 17: View of Flated Portion of Shafts Figure 17: View of Flated Portion of Shafts
N O T E S N O T E S N O T E S N O T E S N O T E S
> >> > > The flow meter uses alignment
pins to ensure that the two body
halves can only be assembled in
one way.
N O T E N O T E N O T E N O T E N O T E
5. Snug all screws down. Tighten the screws in
the sequence pattern shown in Figure 4 to 13 lbs.
per ft. torque. This is a cross pattern to insure
proper gasket setting.
6. Install transmitter on to body.
7. Reconnect meter into system.
ARCHIVE