Ransburg RF1 FiberOptic Meter 77786-XX, A11516-XX - Manual (Page 15)

FM-00-02.5 1 1 1 1 11 1 1 1 1
RF 1 Fiber Optic - Installation
INST INST INST INST INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
Ensure proper fluid filtration is provided on the inlet
side of the flow meter. The unit may be mounted
using the mounting bolt pattern shown in Figure 4.
Two (2) 1/4 - 20 bolts should be used. Always
mount the flow meter with the gear faces
perpendicular to the horizon of the earth (i.e. -
Vertical). This minimizes the effect of gravity on
the gears. The direction of flow must be plumbed
as marked on the side label of the meter. The fluid
inlet is opposite the sensor connection.
High Pressure / Side Inlet High Pressure / Side Inlet High Pressure / Side Inlet High Pressure / Side Inlet High Pressure / Side Inlet
Figure 4: Views of Flow Meter Bodies Figure 4: Views of Flow Meter Bodies Figure 4: Views of Flow Meter Bodies Figure 4: Views of Flow Meter Bodies Figure 4: Views of Flow Meter Bodies
Low Pressure / Bottom Inlet Low Pressure / Bottom Inlet Low Pressure / Bottom Inlet Low Pressure / Bottom Inlet Low Pressure / Bottom Inlet
> > > > > For waterborne applications the
meter body should be isolated from
ground.
N O T E N O T E N O T E N O T E N O T E
ARCHIVE