Ransburg HV Controller A12311 - Manual (Page 11)

NOTES Fault LED
The red Fault LED is lit when the system detects
a fault condition (see "Figure 3 - Power Switch" in
this section). When operating in "Local Mode", it
is cleared by flipping the HV On/Off switch to the
Off (Reset) position. If the system is still in a fault
condition, it will immediately be lit as the system
detects the fault.
High Voltage LED
The green High Voltage LED displays the current
state of the High Voltage Output. This LED is illu-
minated whenever High Voltage is being supplied.
BUTTONS
The six buttons used to control the viewing and
entry of information on the 4 X 20 character dis-
play are:
Screen Button
The Screen Button (at the top) is used to change
(toggle) to the next Menu screen. The menu
screens wrap around so that after the last screen
it will return to the first screen.
Up and Down Buttons
The buttons above and below the Set Button in
the middle (the Up and Down Buttons) are used to
change which value on the screen is to be changed.
Set Button
This labeled button (in the middle) is used to select
the value to change and to enter the change after
it has been made.
Increase and Decrease Buttons
The buttons to the right and left of the Set Button
are the Increase and Decrease Buttons. They
are used to change the value selected by the
Set Button.
High Voltage Controller - Introduction
9
Ransburg
LN-9623-00.1