Trinity 12 analog specifications – LumaStream Trinity 12 Analog User Manual
Page 2
![background image](/manuals/348060/2/background.png)
Trinity 12 Analog Specifications
Input
Output
System Protection
Safety and EMI/EMC
Environmental
Control Interface
Rated Input Voltage
115 to 277 Vac hard wired ; 115 to 125 Vac power cord
Rated Input Frequency
47 - 63 Hz
Power Factor EN61000-3-2
@ 115 Vac, 100% load, 0.97 W/VA min
Input Current Total Harmonic Distortion @ 115 Vac, 100% load, 13% max
Rated Output Power
@ 40°C / 104°F ambient, 243 W max
Output Voltage
66 series: 6 to 27 Vdc; 70 series: 12 to 47 Vdc
Efficiency
87% with 100% load @ 115 Vac input
System Power Cycle Delay
2 second typical time required for stabilization of all outputs
Output Current Tolerance
+/-5 % of nominal
Output
Over voltage, over current, short circuit protection
Over Temperature
Power supply will shut down when external ambient temperature
exceeds 43°C/ 109.4°F or case temperature reaches 85°C/ 185°F
nominal.
Output Interconnection
Hiccup mode with automatic recovery upon removal of short. Only
applies to +ve to -ve interconnections.
Agency Approvals
UL 8750 Class 2 outputs
Conducted and Radiated Emissions
ICES-003; FCC Title 47, Part 15, Class A (for commercial use only)
EN61000-3-2
Harmonics Emissions, Class C
EN61000-4-4
Electrical Fast Transient, 1KV Criteria B
EN61000-4-5
Surge, 2KV Criteria B
EN61000-4-11
Voltage Dips, Interruptions, and Voltage Variations, according to
EN61547
Location Rating
Dry
Operating Ambient Temperature
-20°C to 40°C / -4°F to 104°F
Cold Start Temperature
-20°C / -4°F
Storage Ambient Temperature
-40°C to 80°C / -40°F to 176°F
Relative Humidity
5% to 95% noncondensing
Mean Time Between Failure
(MIL HDBK-217F); (12 channel)
>60,000 hours @ 40°C / 104°F; >97,000 hours @ 25°C / 77°F
Control Method
Analog 0-10 Vdc, IEC 60929 Annex E Outputs 0.5 mA max or variable
0-10 Vdc Voltage Source; Class 2 outputs.
Control Zones
Master control: simultaneous control of all the output channels.
Zonal control: up to 12 independently configurable output channels.
Loss of Analog Input Signal
Outputs will go to 0% or 100% light intensity in less than 1 second; must
set default valve, 0% or 100%
LSPS08 / Trinity 12 Analog 12 Zone
© 2014 LumaStream
www.lumastream.com
+1 (727) 827-2805