Alliance Laundry Systems F232157R7 - Manual (Page 30)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
F232157 28
Agitation Step
Advance the cycle by pressing “
∧” keypad to skip to
the drain step. Filling, supply flushing and other
signals turn off. Cycle remaining time is recalculated
as the total remaining time after the agitation.
Drain Step
Advance the cycle by pressing “
∧” keypad to skip the
drain step and the following spin step. The spin step is
skipped because the drain step needs to be completed
to balance the load. The next programmed step after
the spin begins. Cycle remaining is recalculated as the
total remaining time after the drain and spin steps.
Spin Step
Advance the cycle by pressing “
∧” keypad to skip the
spin step. The next step after the spin begins. Cycle
remaining is recalculated as the total remaining time
after the spin step.
Temporary Free Mode
An authorized operator can enable a Free Cycle
operation that overrides the programmed vend start
amount. After running the Free Cycle, which can be
any of the eight cycles, the control reverts to the usual
programmed vend.
NOTE: The cycle counter DOES count the free
cycle.
• To run a temporary Free Cycle, follow the steps
below. Enter PROGRAM Mode. Display shows
“0000” or temperature or “tSFL” (depending on
version of control).
• Press the (∨) keypad. Display shows “FrEE”.
• While display shows “FrEE”, return the
Program/Run switch to the RUN position. Then
press a cycle keypad to select one of the eight
cycles. Press START (Enter) to begin the cycle.
When the cycle concludes, vend reverts to the
programmed amount.
Test Cycle
The test cycle provides a convenient means of
troubleshooting and testing all machine functions
quickly.
1. Enter PROGRAM Mode. Display shows “0000”
or temperature or “tSFL” (depending on version
of control).
2. Press the ( ∨) keypad. Display shows “FrEE”.
3. Press the START (Enter) keypad. Display shows
“tESt”.
4. Return the Program/Run switch to the right.
Display will show the vend price.
5. Enter coins or make payment so that the vend
amount counts down. When vend is satisfied, the
display will show “tESt” and the START (Enter)
keypad LED will flash on and off. Press the
START (Enter) keypad to begin the test cycle.
6. Press START (Enter) keypad. The door locks and
the TEST Mode starts.
7. Display shows “SPC?”. This is a special factory
test procedure. Simply ignore it and the machine
will advance into the test cycle after about
five seconds or go to “bAL?” if variable-speed.
NOTE: For variable-speed models ONLY, display
shows “bAL?”. This is a factory test. Disregard the
display. Machine will begin the test cycle after a
few seconds.