beautypg.com

Spanning-tree forward-time – Accton Technology Direk Tronik ES4524D User Manual

Page 443

background image

spanning-tree forward-time

51-3

51

Command Usage

• Spanning Tree Protocol

Uses RSTP for the internal state machine, but sends only 802.1D BPDUs.
- This creates one spanning tree instance for the entire network. If multiple

VLANs are implemented on a network, the path between specific VLAN
members may be inadvertently disabled to prevent network loops, thus
isolating group members. When operating multiple VLANs, we recommend
selecting the MSTP option.

• Rapid Spanning Tree Protocol

RSTP supports connections to either STP or RSTP nodes by monitoring
the incoming protocol messages and dynamically adjusting the type of
protocol messages the RSTP node transmits, as described below:
- STP Mode – If the switch receives an 802.1D BPDU after a port’s migration

delay timer expires, the switch assumes it is connected to an 802.1D bridge
and starts using only 802.1D BPDUs.

- RSTP Mode – If RSTP is using 802.1D BPDUs on a port and receives an

RSTP BPDU after the migration delay expires, RSTP restarts the migration
delay timer and begins using RSTP BPDUs on that port.

• Multiple Spanning Tree Protocol

- To allow multiple spanning trees to operate over the network, you must

configure a related set of bridges with the same MSTP configuration,
allowing them to participate in a specific set of spanning tree instances.

- A spanning tree instance can exist only on bridges that have compatible

VLAN instance assignments.

- Be careful when switching between spanning tree modes. Changing modes

stops all spanning-tree instances for the previous mode and restarts the
system in the new mode, temporarily disrupting user traffic.

Example
The following example configures the switch to use Rapid Spanning Tree:

spanning-tree forward-time

This command configures the spanning tree bridge forward time globally for this
switch. Use the no form to restore the default.

Syntax

spanning-tree forward-time seconds
no spanning-tree forward-time

seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].

Console(config)#spanning-tree mode rstp
Console(config)#

This manual is related to the following products: