Accton Technology Direk Tronik ES4524D - Manual (Page 291)

34-1
Chapter 34: System Management Commands
This section describes commands used to configure information that uniquely
identifies the switch, and display or configure a variety of other system information.
hostname
This command specifies or modifies the host name for this device. Use the no form
to restore the default host name.
Syntax
hostname name
no hostname
name - The name of this host. (Maximum length: 255 characters)
Default Setting
None
Command Mode
Global Configuration
Example
Table 34-1 System Management Commands
Command Function Mode Page
hostname Specifies the host name for the switch GC 34-1
reload Restarts the system PE 34-2
switch renumber Renumbers stack units PE 34-2
jumbo frame Enables support for jumbo frames GC 34-9
show startup-config Displays the contents of the configuration file (stored in flash
memory) that is used to start up the system
PE 34-3
show running-config Displays the configuration data currently in use PE 34-5
show system Displays system information NE, PE 34-7
show users Shows all active console and Telnet sessions, including user
name, idle time, and IP address of Telnet clients
NE, PE 34-7
show version Displays version information for the system NE, PE 34-8
Console(config)#hostname RD#1
Console(config)#