Finish Thompson S6 BATTERY REPLACEMENT - Manual (Page 5)

Battery Pack Installation
1. Route red & black motor leads through the side openings of the new battery pack. See Figures 19 & 20.
2. Make sure motor lead wires are not in the battery alignment slots. Slots must be clear in order to slide the battery
down properly.
See Figure 21. Slide the new battery pack into the motor canister (item 4) with the circuit board facing
motor handle. See Figure 22.
Figure 22
Figure 20
Figure 21
Figure 19
Illustration shows
motor wires in slot.
3. Push the battery pack gently down until it bottoms out. Roughly ½” from top of motor canister. See Figure 23.
4. Install the red motor lead wire connector onto the motor terminal marked with a red dot. See Figure 24.
5. Install the black lead wire connector on the other motor terminal. See Figure 25.
Figure 25 Figure 24 Figure 23