Fairbanks 3300 Reliant Series Floor Scale - Manual (Page 9)

A. Introduction
The Reliant series floor scales have several accessory options available. These accessories
are Bolt-down plates, Ramps, and Bumper-Guards.
B. Bolt-Down Plates
Bolt down plates are used to keep the scale from sliding or moving when loads are applied. The
plates are bolted via anchors at each of the scale’s feet.
1. Installation
a. Place the platform in position.
b. Place the bolt-down plate under the foot, plate edge extending out from
under the scale.
c. Drill the two (2) holes using a hammer drill. Insert anchors with the nut
and washer already ON. Tap the anchor into the hole, then tighten the
nuts securely. Repeat this process for each plate used.
C. Ramps
Each mild steel ramp accessory comes with two integral bolt down plates and four anchors.
1. Installation
a. Place the ramp in position, then lift and set the platform feet into the bolt-
down plate holes.
b. Drill the two (2) holes using a hammer drill. Insert the anchors with the
nut and washer already ON. Tap the anchor into the hole then tighten the
nuts securely.
• If two ramps are installed, NO other bolt-down plates are needed.
• If one ramp is installed, a set of two bolt-down plates is needed
• Only two ramps total may be installed on opposite sides of a
scale platform.
10/06 9 50783 Issue 2
Section 4: Accessories
Note:
If ramps are NOT installed and bolt-down plates are needed, a set of four bolt-down plates will
be required.