Earthway M21P Commercial 12-Volt Broadcast Spreader - Manual (Page 6)

M21 Series Mounts
77021 TRUCK MOUNTING INSTRUCTIONS
Attach the hitch to your 2” receiver hitch on your vehicle. (Truck hitch pin not
included)
Remove the hitch pins from the spreader frame and mount the spreader to the hitch.
Connect to 12-volt power source (lighter or wire to battery) then attach pull cord to
rope loop on gauge assembly.
77011 UNIVERSAL MOUNTING INSTRUCTIONS
Attach the mounting bracket to the front or rear vertical rack on your ATV, or on
any flat vertical surface using the U-bolts included or hardware you source that
will hold 500lbs. of shear force. The optional holes will allow for different brands
of racks, or vehicles, and positioning.
Make sure that the spreader sits level to the ground or tipped up slightly at the rear
for best performance.
Remove the hitch pins from spreader and mount to mounting bracket.
Connect to 12-volt power source (lighter or wire to battery) then attach pull cord to rope loop on
gauge assembly.
77012 3-POINT HITCH MOUNTING INSTRUCTIONS
Attach the mounting bracket to the lift arms on your tractor, then attach the top-link and level.
This is a Category 0 model.
Make sure that the spreader sits level to the ground or tipped up slightly at the rear for best
performance.
Remove the hitch pins from spreader and mount to mounting bracket.
Connect to 12-volt power source (lighter or wire to battery) then attach pull cord to rope loop on
gauge assembly.
77013 GATOR® MOUNTING INSTRUCTIONS
Attach the mounting bracket to the rear vertical frame on your Gator using bolts
included or hardware you source that will hold 500lbs. of shear force. This
mount is design for all models (up to 2004) but the Electric & Turf Gator®
Make sure that the spreader sits level to the ground or tipped up slightly at the
rear for best performance.
Remove the hitch pins from spreader and mount to mounting bracket.
Connect to 12-volt power source (lighter or wire to battery) then attach pull cord
to rope loop on gauge assembly.