Spread path, Full rate, Half rate – Earthway C24HDS Stainless Steel Professional 100lb/45kg Broadcast Spreader User Manual

Page 5

18. For normal operation both doors should be fully opened. To reduce flow to the left side, partially or completely close the door over the

rear (LARGE) hole. To reduce flow to the right side, partially or completely close the door over the front (SMALL) hole. Close both doors

for a narrow center spread pattern.
WARNING: If the optional side deflector is being used in the down position, the plate over the rear (LARGE) hole MUST BE CLOSED

or an over application of material will occur.

The settings furnished on the Setting Matrix are intended as a guide only. Variations in physical characteristics of material applied, walking

speed, and roughness of ground surface may require slightly different spreader settings. Due to these conditions, Earthway Products, Inc.

makes no warranty as to the uniformity of coverage actually obtained from the settings listed.

read

Patter

Each adjustable port

has 8 positions

One port closed

Both ports closed

Both ports open



FULL Rate

(one pass)

HALF Rate

(two passes)

SPREAD PATH

OPERATING INSTRUCTIONS

Before filling hopper, become familiar with the operation of this spreader.

Obtain proper setting for material to be used from the enclosed SETTING MATRIX included with this spreader, or from our web site

under the MANUALS SECTION.

Move stop bolt on rate gauge assembly to the proper setting.

While pushing spreader forward, pull control lever back to stop bolt.

To stop, push lever forward to close flow holes before you stop moving.

When finished, empty any remaining material from hopper.

Thoroughly wash spreader and allow to dry before storing. Apply coating of light oil to help prevent corrosion.

If you use Rock Salt, remove agitator when using Rock Salt to prevent damage to the gearbox.

Earthway Products, Inc.

1009 Maple Street, PO Box 547

Bristol, IN 46507

For Your Records

Date Purchased

Place of Purch

ase

HOW TO ORDER SPARE PARTS

All spare parts listed may be ordered direct from

EarthWay Products, Inc.

Be sure to give the following information when ordering.

Model Number

Part Number

Part Description

Call (574) 848-7491, 800-294-0671, or email: [email protected]

for current prices.

5-YEAR LIMITED WARRANTY

Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 5-Years to the end user

with the original purchase receipt. If a manufacturing non-conformance is found, Earthway Products, Inc. at its discretion will repair or

replace the part(s) or product at no charge provided the failure is not the result of incorrect installation, mishandling, misuse, tampering, or

normal wear and tear as determined by Earthway. Earthway at its discretion may require that the part(s) or product be returned along with

the original purchase receipt at owners’ expense for examination and compliance with the terms of this warranty. Do not return any product

without first receiving authorization from Earthway Products, Inc. To seek remedy under this warranty, contact Earthway Products, Inc. at

574-848-7491, [email protected] or write to Earthway Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe the nature

of the manufacturing defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor charges associ-

ated with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of most fertilizers and ice melt

products, Earthway Products, Inc. makes no warranty against and specifically excludes part(s) or product degradation or failure due to cor-

rosion or its effects. Clean and dry your spreader thoroughly after each use, as a preventative measure, coat all metal parts with a light oil or

silicon spray.

PAGE 5

This manual is related to the following products:

C24HD Professional 100lb/45kg Broadcast Spreader