Earthway 2600APlus Medium-Duty Estate Broadcast Spreader - Manual (Page 2)

1/4 - 20 Lock-nut
1/4 - 20 x 1-1/2” Bolt
Handle Shaft
Slide
Right
Side
Left
Side
Slide Axle through as shown
1/4-20 x 2-1/4”
Bolt
1/4-20 x 2-1/4”
Bolt
Axle Bearing
Flat
Side
Notch
4. Install lower handles onto Frame and secure with ¼-20 x 2¼” bolt
through hole in Frame Braces and through the hole in frame install
locknut.
N
ext
, S
lide the axle
(C
oaSt
W
heel Side firSt
) through the right
side lower handle and into the gearbox (with the arrow facing the
FRONT), you will need to rotate the axle to engage with the gearbox,
then through the left side lower handle.
TURN SPREADER UPRIGHT ON TO WHEELS.
PAGE 2
8. Install Handle Shaft as shown below using (2) 1/4-20 x
1½” Hex Bolt and (2) 1/4-20 Locknuts
5. Install the bearings over the axle and
press into the notches of the lower
handle as shown above.
Right
Side
DRIVE WHEEL
Left
Side
COAST WHEEL
Slide wheels on axle as shown
33106
1/8" X 3/4" Cotter Pin
33107
1/8" X 1-3/4" Cotter Pin
34103
1" OD. Washer
~~~IMPORTANT~~~
Coast Drive
Upper Handle
1/4 - 20 Lock-nut
1/4 - 20 x 1-1/2” Bolt
6. Install drive wheel to axle using pin hole nearest to lower handles
as shown. Insert 1¾” Cotter pin through wheel and through axle.
Bend with pliers to prevent pin from falling out.
7. Install coast wheel to axle using outside pin hole. As shown, add the
flat washer, and insert ¾” Cotter pin through axle (not thru the wheel). Bend with pliers to prevent pin from falling out.
NOW GO BACK AND TIGHTEN ALL NUTS
AND BOLTS, DO NOT OVER TIGHTEN.
9. Insert (2) 1/4-20 x 1½” Hex Bolt
through Gauge and Linkage Assembly, then through the Upper Handle, Handle
Shaft, Upper Handle and secure with (2) 1/4-20 Locknuts as shown at the right.