Earthway 2130SS Commerical HIGH-OUTPUT Broadcast Spreader - Manual (Page 3)

5-YEAR LIMITED WARRANTY
Earthway Products, Inc. warrants this product free of defects in original workmanship and materials for a period of 5-Years
to the end user with the original purchase receipt. If a manufacturing non-conformance is found, Earthway Products, Inc.
at its discretion will repair or replace the part(s) or product at no charge provided the failure is not the result of incorrect
installation, mishandling, misuse, tampering, or normal wear and tear as determined by Earthway. Earthway at its
discretion may require that the part(s) or product be returned along with the original purchase receipt at owners’ expense for
examination and compliance with the terms of this warranty. Do not return any product without first receiving authorization
from Earthway Products, Inc. To seek remedy under this warranty, contact Earthway Products, Inc. at 574-848-7491,
[email protected] or write to Earthway Products, Inc. P.O. Box 547 Bristol, Indiana 46507 and describe the nature
of the manufacturing defect. SPECIFIC LIMITATIONS: This warranty covers only the part(s) or product; any labor
charges associated with repair or replacement of non-conformances are specifically excluded. Due to the corrosive nature of
most fertilizers and ice melt products, Earthway Products, Inc. makes no warranty against and specifically excludes part(s)
or product degradation or failure due to corrosion or its effects. Clean and dry your spreader thoroughly after each use, as a
preventative measure, coat all metal parts (inside and outside of the steel tubing) with a light oil or silicon spray.
HOW TO ORDER SPARE PARTS
All spare parts listed herein may be ordered direct from the
manufacturer. Be sure to give the following information when
ordering.
 Model Number
 Part Number
 Part Description
Call (574) 848-7491 or 800-294-0671 to place an order with a
credit card.
OPERATING INSTRUCTIONS
Before filling hopper, become familiar with the operation of
this spreader.
; Move stop bolt on gauge assembly to the proper position
for the material being applied.
; While pushing spreader forward, push control lever
forward to stop bolt.
; To stop, pull lever backward to close flow hole before you
stop moving.
; When finished, empty any remaining material from
hopper.
; Thoroughly wash and dry your spreader before storing.
PAGE 3
DO NOT RETURN TO DEALER FOR REPAIR
EARTHWAY PRODUCTS, INC.
1009 Maple Street
P.O. Box 547
Bristol, IN 46507
FOR YOUR RECORDS
Date Purchased
Store Name