Earthway S25 SPRAY-PRO PUSH SPRAYER - Manual (Page 2)

8. Next, Install Control Rod into Valve Adapter by pressing onto
the Valve Adapter located at the back of the sprayer skirt, shown
below right. Install the Control Rod by installing flattened end
of Control Rod into Valve Adapter, shown below right.
NOTE: Make sure that the V
alVe
H
andle
and
the C
ontrol
r
od
H
andle
point in the SAME
DIRECTION.
Finally, install the Gun Holder onto the lowest bolt (closest
to the sprayer TANK) and secure with a 2” bolt and
locknut.
Be sure to position the Gun Holder as show above.
TIGHTEN NOW.
PAGE 2
Long End
holes farther
from one end Handle Shaft
12344
Handle
Spacer
32103
1/4-20 Lock Nut
31120
2” HHCS
5. Install handle shaft to lower handles as
shown. Using 2” bolts and locknuts.
Make sure that you install the
handle shaft with the long end
facing toward the sprayer.
TIGHTEN BOLTS AND NUTS NOW.
¼-20 x 2”
Hex Head Bolt
Handle
Spacer
Upper Handles
¼-20
Locknuts
POSITIONS
LOWER
UPPER
Handle Shaft
Spray Gun Holder
SPRAY TRANSPOR
T
VERY IMPORTANT
Control Rod Handle MUST point in the
same direction as the VALVE HANDLE
Nut Protector
6. NOTE: Before installing the Gun Holder and Upper Handles to the
Handle Shaft, the Upper Handles have (3) three positions for operators
comfort. If operator chooses the middle or upper positions, please use
the Handle Spacer. Install the Handle Spacer in hole nearest the handle
grips as shown to the right. Insert 2” bolt through Upper Handle, then
through Handle Spacer and then through other Upper Handle, then
secure loosely ¼-20 locknut. Now install one 2” bolt, so that it goes
through the top hole in the handle shaft and secure with ¼-20 locknut.
TIGHTEN BOLTS AND NUTS NOW.
7. Install Control Rod into the Gun Holder as shown below. Next install
black nut protector to the short leg on Control Rod.