Fire Fighting Enterprises FIRERAY 3000 - Manual (Page 12)

12
13. Delay To Fire
This setting is the delay the System Controller uses before signalling a FIRE condition to the
Fire Control Panel. Default factory setting=10 seconds.
(Set for each Receiver).
14. Delay To Fault
This setting is the delay the System Controller uses before signalling a FAULT condition to the
Fire Control Panel. Default factory setting=10 seconds.
(Set for each Receiver).
15. Latching/Non-Latching Mode
In Latching Mode the system will stay in Fire condition after the fire clears. In Non-Latching
Mode the system will automatically return to normal condition after the fire clears
Default factory setting=Non-Latching (Set for each Receiver).
To clear a latched fire, apply 5-40V to the External Reset terminal, enter the passcode, or
power cycle for 20s.
Use to move between icons in
the Receiver Menu, until the graph and bell
icons are shown
Non-Latching
Latching