FEC AFC1200 User Manual
Page 15
)(& ,QF
Common from power supply (0 VDC).
0 VDC COM
0 VDC COM
33
34
Common for PLC Output (0 VDC).
OUT COM
OUT COM
31
32
Bank Data Output Signals (Normally Open)
These output signals designate various fastening conditions and
results as determined by Bank Select 0 & 1 (Pins 21 & 22) inputs.
Refer to 4.7.3 Bank Select Table for output data descriptions.
BANK DATA 0
BANK DATA 1
BANK DATA 2
BANK DATA 3
BANK DATA 4
BANK DATA 5
BANK DATA 6
BANK DATA 7
23
24
25
26
27
28
29
30
OUTPUT SIGNALS
Bank Select Input Signals (Normally Open)
These two (2) inputs form a binary code that is used to define the
function/definition of outputs for Bank Data 0~7 (Pins 23~30). This
allows up to 32 different output definitions with only 8 discrete outputs
(4 Banks, 8 available outputs per Bank). See 4.7.3 Bank Select Table.
BANK SELECT 0
BANK SELECT 1
21
22
Bypass Head Input (Normally Open)
These four (4) inputs are available, as appropriate, to bypass the
heads (groups of spindles) designated A, B, C or D (on the Machine
Configuration screen).
BYPASS HEAD A
BYPASS HEAD B
BYPASS HEAD C
BYPASS HEAD D
17
18
19
20
External Sequence Input (Normally Open)
These four (4) signals are available for use, as appropriate, as
external sequence inputs to the fastening sequence. When a [WAT]
wait command is programmed as a step in the fastening sequence, the
sequence will stop until the designated external input is active.
INPUT PORT 1
INPUT PORT 2
INPUT PORT 3
INPUT PORT 4
13
14
15
16
DESCRIPTION
SIGNAL NAME
Pin #
CAUTION:
DO NOT CONNECT A POSITIVE DC VOLTAGE SOURCE TO THE INPUT
COMMON OR OUTPUT COMMON, OR DAMAGE MAY RESULT.
4.7.2 Sequence Select Table
SEQUENCE 8
ON
ON
ON
SEQUENCE 7
OFF
ON
ON
SEQUENCE 6
ON
OFF
ON
SEQUENCE 5
OFF
OFF
ON
SEQUENCE 4
ON
ON
OFF
SEQUENCE 3
OFF
ON
OFF
SEQUENCE 2
ON
OFF
OFF
SEQUENCE
OFF
OFF
OFF
WARNING:
Follow Lockout/Tagout and other safety precautions when connecting and/or
disconnecting cabling, wiring, and equipment.
Chapter 4: System Setup and Wiring
User Console Version A3.53
Page 4-15