Fulton Vertical Coil (FT-C_S) Thermal Fluid (hot oil) Heater - Manual (Page 71)

Questions? Call (315) 298-5121, or visit us online at www.fulton.com
4-3
SECTION 4
FTCS-IOM-2013-1114
MAINTENANCE
!
WARNING
All information in this manual is for
reference and guidance purposes,
and does not substitute for required
professional training, conduct,
and strict adherence to applicable
jurisdictional/professional codes and
regulations.
Fluids under pressure are hazardous
and may cause injury to personnel, or
equipment damage, when released.
Shut off all incoming and outgoing
fl uid shutoff valves and carefully
decrease all trapped pressures to zero
before performing any maintenance.
Never use open fl ame or other sources
of ignition to check for gas leaks.
4
CAUTION
All maintenance procedures should
be completed by trained personnel.
Appropriate training and instructions
are available from the Fulton Service
Department at (315) 298-5121 or your
local Fulton Thermal Representative.
In order to meet warranty conditions,
ensure all appropriate maintenance
activities are performed.
Use caution when using any cleaning
solutions. Refer to local regulations for
proper cleaning solution disposal.
All maintenance procedures should
be completed by trained personnel.
Appropriate training and instructions
are available from the Fulton Service
Department at (315) 298-5121 or your
local Fulton Thermal Representative.
In order to meet warranty conditions,
ensure all appropriate maintenance
activities are performed.
5. In systems utilizing linkage, check all linkage components for tightness.
(Figure 25)
6. In systems utilizing a water cooled thermal fl uid circulating pump, check
level of lubricating oil in self-leveling reservoir and check cooling water
circulation loop for proper operation. See Figure 26.
FIGURE 25- LINKAGE COMPONENTS
FIGURE 26 - WATER-COOLED THERMAL FLUID CIRCULATING PUMP
FIGURE 27 - GAS TRAIN