Bosch NCT615C01 Table électrique 60cm - Manual (Page 19)

„
Provide an omnipolar cut-off switch with a minimum
contact separation of 3mm (except in plug
connections, so long as the user has access to it).
„
This appliance is type “Y”: The entrance cable can
only be changed by the Technical Assistance Service,
section must be respected.
„
The hob is fitted with a 6 x 1,5mm2 electrical cable
made of silicone suitable for a 220-230V, 2 phase
„
For safety reasons, the earthwire must be the first to
connect, and the last to disconnect.
Removal of cooking hob
„
Turn off the appliance’s electricity supply.
„
Unscrew the clamps and proceed in reverse order to
the installation.
and not by the user. The cable type and minimum
connection. For any other connectioon, see figure 5.
18