Bosch NCT615C01 Table électrique 60cm - Manual (Page 13)

Do not clean the appliance using steam cleaners. Risk of
electrocution!
The graphics in this instruction manual are given as a
guide only.
Electric hotplates
Before using for the first time
To remove the new smell, switch the hotplates on to full
power for five minutes, one by one, without placing any
pans on top. Do not switch more than one hotplate on at
a time. At this point it is normal to notice smoke and
odours, but these will disappear over time.
pans on top, except during this initial heating phase.
Operation
Switching on
Setting 1: low power.
Setting 6 or 9 (depending on the model): full power
Switching off
Turn the knob clockwise to the off setting.
Tip It is recommended to start cooking on full power and
then to use intermediate power levels after a few
minutes.
Residual heat
The electric hotplates can be switched off slightly before
the end of the cooking time. The residual heat will enable
energy.
you to continue cooking for several minutes, thus saving
12
Caution! Do not operate the hotplates without placing
Turn the knob anticlockwise to the required setting.
Fig. 1 or 2 depending on the model.