Bosch TES50129RW VeroCafe Machine à café Expresso automatique Noir - Manual (Page 9)

9
TES501.. 08/2011
en
“Coffee strength” rotary knob
This rotary knob (13) is used
to adjust the coffee strength
or select the setting for pre-
ground coffee.
h
to
g
G
Very mild
Mild
Medium
Strong
Ground coffee
“Drink selection” rotary knob
This rotary knob (14) is
used to select the required
beverage and quantity. It is
also used to change user
settings.
a
to
c
Small espresso
Espresso
Small café crème
Café crème
Large café crème
b
to
d
2 small espressos
2 espressos
2 small café crèmes
2 café crèmes
2 large café crèmes
Milk frother
Pull the milk frother (6a) out to open it and
push it back in to close it.
Before using for
the fi rst time
General
Fill the water tank with fresh, uncarbonated
water only and preferably use only beans
or coffee blends suitable for fully automatic
espresso and coffee machines. Do not
use coffee beans that have been glazed,
caramelised or treated with other additives
containing sugar, since they will block the
brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory setting for the
water hardness is 4. Check the hardness
of the water you use with the enclosed test
strip. If the test reveals a value other than
4, change the setting on the appliance ac-
cordingly after switching on (see “Settings”,
“Water hardness” on page 11).
Setting up the appliance
1. Place the fully automatic espresso ma-
chine on a fl at, water-resistant surface
that can take its weight. The ventila-
tion slots on the appliance must not be
covered.
2. Pull out the mains plug from the cable
compartment (20) and plug it in. Adjust
the length of the cable by pushing it
back in and pulling it out. To do this,
place the appliance with its back fl ush
with the edge of the work surface and
either pull the cable downwards or
push it upwards.
3. Assemble the milk frother. Only use the
appliance when the milk frother (6) is
completely assembled and fi tted.
TES501_Heft1_RW.indb 9 14.09.2011 16:10:24