beautypg.com

5 trunk commands set, Table 3.5: trunk commands set – Advantech EKI-7657C User Manual

Page 40

background image

EKI-7657C _Manual_ed1 30

bandwidth type all

I

Set interface ingress limit frame
type to “accept all frame”

switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type all

bandwidth type broadcast-multicast-
flooded-unicast

I

Set interface ingress limit frame
type to “accept broadcast,
multicast, and flooded unicast
frame”

switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-
multicast-flooded-unicast

bandwidth type broadcast-multicast

I

Set interface ingress limit frame
type to “accept broadcast and
multicast frame”

switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-
multicast

bandwidth type broadcast-only

I

Set interface ingress limit frame
type to “only accept broadcast
frame”

switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type broadcast-only

bandwidth in

[Value]

I

Set interface input bandwidth. Rate
Range is from 100 kbps to 102400
kbps or to 256000 kbps for giga
ports,
and zero means no limit.

switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth in 100

bandwidth out

[Value]

Set interface output bandwidth.
Rate Range is from 100 kbps to
102400 kbps or to 256000 kbps for
giga ports,
and zero means no limit.

switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth out 100

show bandwidth

I

Show interfaces bandwidth control

switch(config)#interface fastEthernet 2
switch(config-if)#show bandwidth

state

[Enable | Disable]

I

Use the state interface
configuration command to specify
the state mode of operation for
Ethernet ports. Use the disable
form of this command to disable
the port.

switch(config)#interface fastEthernet 2
switch(config-if)#state Disable

show interface configuration

I

show interface configuration status

switch(config)#interface fastEthernet 2
switch(config-if)#show interface configuration

show interface status

I

show interface actual status

switch(config)#interface fastEthernet 2
switch(config-if)#show interface status

show interface accounting

I

show interface statistic counter

switch(config)#interface fastEthernet 2
switch(config-if)#show interface accounting

no accounting

I

Clear interface accounting
information

switch(config)#interface fastEthernet 2
switch(config-if)#no accounting


3.1.5

Trunk Commands Set

Table 3.5: Trunk Commands Set

Netstar Commands

Level

Description

Example

aggregator priority

[1~65535]

G

Set port group system priority

switch(config)#aggregator priority 22

aggregator activityport

[

Group ID

]

[Port Numbers]

G

Set activity port

switch(config)#aggregator activityport 2

aggregator group

[GroupID] [Port-list]

lacp
workp

[Workport]

G

Assign a trunk group with LACP
active.
[GroupID] :1~3
[Port-list]:Member port list, This
parameter could be a port
range(ex.1-4) or a port list separate
by a comma(ex.2, 3, 6)
[Workport]: The amount of work
ports, this value could not be less
than zero or be large than the
amount of member ports.

switch(config)#aggregator group 1 1-4 lacp workp
2

or

switch(config)#aggregator group 2 1,4,3 lacp
workp 3