Advantech EKI-7657C - Manual (Page 39)

29 Chapter3
dhcpserver subnetmask
[Subnet mask]
G
Configure subnet mask for DHCP
clients switch(config)#dhcpserver subnetmask
255.255.255.0
dhcpserver gateway
[Gateway] G
Configure gateway for DHCP clients switch(config)#dhcpserver gateway 192.168.1.254
dhcpserver dnsip
[DNS IP]
G
Configure DNS IP for DHCP clients switch(config)#dhcpserver dnsip 192.168.1.1
dhcpserver leasetime
[Hours] G
Configure lease time (in hour) switch(config)#dhcpserver leasetime 1
dhcpserver ipbinding
[IP address]
I
Set static IP for DHCP clients by port switch(config)#interface fastEthernet 2
switch(config)#dhcpserver ipbinding 192.168.1.1
show dhcpserver configuration P Show configuration of DHCP server switch#show dhcpserver configuration
show dhcpserver clients P Show client entries of DHCP server switch#show dhcpserver clients
show dhcpserver ip-binding
P
Show IP-Binding information of
DHCP server switch#show dhcpserver ip-binding
no dhcpserver
G
Disable DHCP server function switch(config)#no dhcpserver
security enable
G
Enable IP security function switch(config)#security enable
security http
G
Enable IP security of HTTP server switch(config)#security http
security telnet
G
Enable IP security of telnet server switch(config)#security telnet
security ip
[Index(1..10)] [IP Address]
G
Set the IP security list switch(config)#security ip 1 192.168.1.55
show security
P
Show the information of IP security switch#show security
no security
G
Disable IP security function switch(config)#no security
no security http
G
Disable IP security of HTTP server switch(config)#no security http
no security telnet G
Disable IP security of telnet server switch(config)#no security telnet
3.1.4 Port Commands Set
Table 3.4: Port Commands Set
Netstar Commands Level Description Example
interface fastEthernet
[Portid] G
Choose the port for modification. switch(config)#interface fastEthernet 2
duplex
[full | half]
I
Use the duplex configuration
command to specify the duplex
mode of operation for Fast
Ethernet. switch(config)#interface fastEthernet 2
switch(config-if)#duplex full
speed
[10|100|1000|auto]
I
Use the speed configuration
command to specify the speed
mode of operation for Fast
Ethernet., the speed can’t be set to
1000 if the port isn’t a giga port..
switch(config)#interface fastEthernet 2
switch(config-if)#speed 100
no flowcontrol
I
Disable flow control of interface switch(config-if)#no flowcontrol
security enable
I
Enable security of interface switch(config)#interface fastEthernet 2
switch(config-if)#security enable
no security
I
Disable security of interface switch(config)#interface fastEthernet 2
switch(config-if)#no security