Alcatel-Lucent Omni 6600 User Manual
Page 29

OmniSwitch 6600 Family Chassis and Hardware Components
OmniSwitch 6600-U24
OmniSwitch 6600 Family Hardware Users Guide
September 2006
page 2-5
OmniSwitch 6600-U24 Front Panel
CONSOLE
EXPANSION/STACKING
EXPANSION
25
26
2 7
2 8
TM
OmniSwitch 6600-U24
OK1
OK2
PS1
PS2 PRI SEC
TEMP
FAN
SEL
3
5
7
9
11
13
15
17
19
21
23
1
LINK/ACT
LINK/ACT
2
24
2
1
4
3
6
5
8
7
10
9
12
11
14
13
16
15
18
17
20
19
22
21
24
23
100 Fiber Ethernet SFP Ports
The OS6600-U24 provides 24
fiber 100 Ethernet SFP ports.
These ports can use the SFP-100-
LC-MM, SFP-100-LC-SM, and
SFP-100-MTRJ-MM transceivers
in any combination.
Console Port
The OS6600-U24 front panel provides one RJ-45
port for console connections. Serial console con-
nections are used by network administrators for
switch management. This female RJ-45connector
provides a DCE console connection.
Stacking or Uplink Module Slot
The OS6600-U24 provides an additional slot
that can accommodate either a stacking mod-
ule or a Gigabit Ethernet uplink module.
If you use a Gigabit Ethernet uplink module
in this slot, the OS66600-U24 must be used
as a stand-alone switch.
A stacking module must be installed in this
slot if the switch is to be used in a stack. For
detailed information on stacking switches,
refer to
Chapter 4, “Managing OmniSwitch
Gigabit Ethernet Uplink Module Slot
The OS6600-U24 provides a dedicated slot for Gigabit Ethernet
uplink modules. This slot supports the following module types:
•
OS6600-GNI-C2—Provides two fixed 1000BaseT copper
connections (uses two RJ-45 connectors). Supports distances
up to 100 meters.
•
OS6600-GNI-U2—Provides two MiniGBIC bays that
support hot-swappable 1000BASE-X MiniGBIC transceivers.
Status and Slot Indicator LEDs
For information on the OS6600-U24’s
status and slot indicator LEDs, refer to
Slot Selector Button
The slot selector button, located
directly beneath the slot indicator
LED, is used to manually assign
slot numbers to switches in stacked
configurations. Refer to
“Managing OmniSwitch 6600
Family Stacks,”
for detailed infor-
mation.