Monitoring stacks, Monitoring stack topology, Monitoring stacks -19 – Alcatel-Lucent Omni 6600 User Manual

Page 127: Monitoring stack topology -19

Managing OmniSwitch 6600 Family Stacks

Monitoring Stacks

OmniSwitch 6600 Family Hardware Users Guide

September 2006

page 4-19

Monitoring Stacks

As shown in the figure below, OmniSwitch 6600 Family stacks can be managed and monitored with
Command Line Interface (CLI) commands, WebView, SNMP, and OmniVista. See

“Monitoring Stack

Topology” on page 4-19

for information on monitoring stack configurations and see

Chapter 2,

“OmniSwitch 6600 Family Chassis and Hardware Components,”

for information on monitoring and moni-

toring stack temperature and chassis configurations.

Managing and Monitoring OmniSwitch 6600 Family Stacks

Note. See the OmniSwitch CLI Reference Guide for complete descriptions of CLI commands.

Monitoring Stack Topology

To monitor the topology of individual switches within a stack or all switches within a stack use the

show

stack topology

command by entering

-> show stack topology

at the CLI prompt. A screen similar to the following will be displayed:

Link A Link A Link A Link B Link B Link B

NI Role State RemoteNI RemoteLink State RemoteNI RemoteLink

---+-----------+---------+---------+-----------+---------+---------+----------

1 PRIMARY ACTIVE 2 27 ACTIVE 2 28

2 SECONDARY ACTIVE 1 51 ACTIVE 1 52

The Role field displays the Chassis Management Module (CMM) role of the switch. The “RemoteNI and
“RemoteLink” fields display how the stacking ports are connected to each other within this stack. “Link
A” refers to the left-hand stacking port (Port 27 on OS6624, OS6600-U24, OS6600-P24, and OS6602-24
switches and Port 51 on OS6648 and 6602-48 switches) and “Link B” refers to the right-hand stacking
port (Port 28 on OS6624, OS6600-U24, OS6600-P24, and OS6602-24 switches and Port 52 on OS6648
and OS6602-48 switches).

OmniSwitch
6624

OmniSwitch 6624 Stack

Stacks can be managed

and monitored through the

console port with CLI

commands.

Stacks can be managed

and monitored through

Ethernet ports with CLI

commands, WebView,

SNMP, and OmniVista.