Bosch TDS3511 weiß schwarz Dampfstation Sensixx B35L - Manual (Page 21)

21
BOSCH
ENGLISH
* Model dependent
You can download this manual from the local homepages of Bosch.
Problem Possible causes Solution
The appliance
makes a pumping
sound.
• Water is being pumped into the
steam tank.
• The water tank is not fitted onto
the housing correctly.
• The sound will not stop.
• This is normal.
• Fit the water tank back onto the hou sing
correctly (you will hear a click).
• If the sound will not stop, do not use
the steam generator and contact an
authorised technical service centre.
Loss of pressure
during ironing.
Steam release button has been
activated for too long a period of
time, that is, it has been pressed
too frequently.
Use the steam release button at intervals.
This improves the ironing result as the
textiles will be steamed, dried and ironed
properly.
Water spots appear
on the garment
during ironing.
May be caused by steam
condensed on the ironing board.
Wipe the textile cover of the ironing board,
and iron any water drops to dry them.
Water spots appear
on the garment
during use of the
“PulseSteam”
function.
Water spots are caused by steam
condensation in the hose when
cooling down after use.
Water drops stop coming out of the
soleplate after using the “PulseSteam”
function for some time.
The hose gets hot
during use.
This is normal. It is caused by the
steam passing through the hose
during steam ironing.
Place the hose on the opposite side so
that you cannot touch the hose during
ironing.
Water leakage from
the boiler.
Drainage plug located at the
bottom of the appliance is loose.
Tighten up the boiler drainage plug with
a coin.
The iron does not stop
steaming after placing
it on the pad (2).
“PulseSteam” function has been
activated by double click.
Just press the trigger once again and the
iron will stop steaming at once.
If the above does not solve the problem, get in touch with our customer service.