Bosch TDS372410E weiß grün Dampfstation Sensixx DS37 ProEnergy - Manual (Page 20)

20
BOSCH
ENGLISH
10
Trouble shooting
Problem Possible causes Solution
Pilot light (6) flashes. • Boiler must be rinsed. • Rinse the boiler according to the cleaning
instructions in this manual.
The steam generator
does not come on.
• There is a connection problem.
• The main power button is not
switched on.
• Check the mains cable (9), the plug and
the socket.
• Set the main power button (7) to the “I”
position (illuminated in red).
The iron does not
heat up.
• The main power button is not
switched on.
• The temperature is set to a low
position.
• Set the main power button (7) to the “I”
position (illuminated in red).
• Set the temperature to the desired
position.
The iron begins
to smoke when
switched on.
• During first use: certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
• During subsequent use: the
soleplate may be soiled.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
Water flows through
the holes on the
soleplate.
• The steam function is being
used before it has reached the
correct temperature.
• The water is condensing inside
the pipes because steam is being
used for the first time or has not
been used for a long time.
• Reduce the steam flow when ironing at
low temperatures.
• Point the iron away from the ironing area
and press the steam release button until
steam is produced.
Dirt comes out
through the
soleplate.
• There is a build up of scale or
minerals in the steam tank.
• Chemical products or additives
have been used.
• Use tap water mixed 50% with distilled
or demineralised water. To prolong the
optimum steam function, mix tap water
with distilled water 1:1. If the tap water in
your district is very hard, mix tap water
with distilled water 1:2.
• Clean the soleplate with a damp cloth.
• Never add products to the water.
The iron does not
produce any steam.
• The boiler is not switched on or
the water tank is empty.
• The water tank is not fitted onto
the housing correctly.
• The steam regulation is set to
the minimum position.
• Set the main power button (7) to the “I”
position (illuminated in red), and/or fill the
water tank.
• Fit the water tank back onto the hou sing
correctly (you will hear a click).
• Increase the steam flow.
The ironed garment
turns dark and/or
sticks to the soleplate.
• The selected temperature is
too high and has damaged the
garment.
• Select a suitable temperature for the
material being ironed and clean the
soleplate with a damp cloth.
The soleplate turns
brown.
• This is a regular consequence of
continued use over a long period
of time.
• Clean the soleplate with a damp cloth.