PASCO EM-8662 Ring Launcher Accessories - Manual (Page 2)

R i n g L a u n c h e r A c c e s s o r y EM -8662
2 www.pasco.com
WARNING: Do not place your face or any part of you body
directly over the top of the iron rod or anywhere in the launch
path.
Using the Induction Coil and Bulb
When used with the EM-8661 Ring Launcher, the Induction Coil
and Bulb allows you to show how voltage induced from the cop-
per coil on the launcher can light the bulb.
Hold the plastic base of the induction bulb over the iron rod so
that the copper coil on the plastic base is near the copper coil on
the Ring Launcher. While holding the induction bulb near the
copper coil, use the other hand to briefly hold down the Launch
Switch.
• The small light bulb will light up..
Technical Support
For assistance with any PASCO product, contact PASCO at:
For the latest information about the EM-8662 Ring Launcher
Accessory, go to the PASCO web site and enter EM-8662 in the
Search window.
Limited Warranty For a description of the product warranty, see the
PASCO catalog.
Copyright
The PASCO scientific 012-07563C Ring Launcher Accessory
Instruction Sheet is copyrighted with all rights reserved. Permission is
granted to non-profit educational institutions for reproduction of any part of
this manual, providing the reproductions are used only in their laboratories
and classrooms, and are not sold for profit. Reproduction under any other
circumstances, without the written consent of PASCO scientific, is prohib-
ited.
Trademarks
PASCO and PASCO scientific are trademarks or registered
trademarks of PASCO scientific, in the United States and/or in other coun-
tries. All other brands, products, or service names are or may be trade-
marks or service marks of, and are used to identify, products or services
of, their respective owners. For more information visit
www.pasco.com/legal.
Product End of Life Disposal Information
This electronic product is subject to disposal and recycling regu-
lations that vary by country and region. It is your responsibility to
recycle your electronic equipment per your local environmental
laws and regulations to ensure that it will be recycled in a manner
that protects human health and the environment. To find out
where you can drop off your waste equipment for recycling,
please contact your local waste recycle/disposal service, or the
product representative.
The European Union WEEE (Waste Electrical and
Electronic Equipment) symbol and on the product
or on its packaging indicates that this product must
not be disposed of in a standard waste container.
Address: PASCO scientific
10101 Foothills Blvd.
Roseville, CA 95747-7100
Phone: +1 916-786-3800 (worldwide)
800-772-8700 (U.S.)
Web: www.pasco.com
Email: [email protected]
Induction Bulb with the Ring Launcher
Copper
Coil
Induction
Bulb
Launch
Switch