PASCO SF-9584B Power Supply User Manual
Page 2
1) On/off switch with lamp
2) Connection jacks for AC
3) Connection jacks for DC
4) Regulating knob for AC
5) Regulating knob for the DC current limiter.
If a current limit is to be set, proceed as follows:
Adjust the voltage adjustment knob (6) to the
desired voltage. Short circuit the DC output con-
nectors with a test lead. Use the current adjust-
ment knob (5) to adjust the maximum current
desired. Remove the short circuit again.
The current is now prevented from exceeding this
value, regardless of the position of the voltage
regulating knob (6).
The maximum current which can be supplied is
shown on the following graph:
0
6) Regulating knob for DC voltage
0
7) Display showing the DC output voltage
0
8) LED (light emitting diode) indicator showing
whether the maximum current limit setting has
been reached. When the maximum current is
being drawn (cf. adjustment knob (5)), then the
LED will light up.
0
9) Display showing the DC output current
10) Display showing the AC output voltage
11) LED indicating whether or not the maximum
value of the current has been reached
(LED lights up).
12) Display showing the AC output current
Maintenance:
No special maintenance of the power supply is
necessary.
Service:
The power supply should only be serviced by
qualified personnel. During the guarantee period,
only personnel approved by Frederiksen A/S may
perform service repairs.
Technical data:
230 V version:
Input voltage:
200 - 242 volts, 50 Hz
Input current:
1.4 amperes
Fuses:
2 ea. 3.15 AT
(no. 4090.15)
Power consumption:
320 watts
115 V version:
Input voltage:
100 - 121 volts, 50/60 Hz
Input current:
2.8 amperes
Fuses:
2 ea. 6.3 AT
(no. 4090.09)
Power consumption:
320 watts
DC:
Output voltage
continuously adjustable:
0-24 volts
output current (0-12 volts): 0-10 amperes
output current (12-24 volts): 0-10/6 amperes
linearly decreasing as shown
Overload protection:
Electronic
Ripple and noise:
< 25 mV pp
Digital displays:
1% +/- 2 LSD
AC:
Output voltage
continuously adjustable:
0-24 volts
Output current:
0-6 amperes
Overload protection:
Electronic
Digital displays:
2% ± 2 LSD
Size:
312 x 225 x 117 mm
Weight:
2.5 kilograms
®